Can I mount my PMA bracket like this??

[cleoncleon]

Alright dudes..
I saw this over on another guys build on another forum.. couldn't find the post, but I did save the picture.. Could I just use a few spacers and some Blu-Locktite and mount my stator bracket like so?

Thanks

 

[cleoncleon]

Here's My plate, extrusive peices already shaved off.
Sitting on this empty case, it fits rather well; its flat across and snug just sitting in place.

Got my plate from Ricky Stator, $22 Shipped.

So yeh... Can I just drill those holes out? Use a few spacers to fill in the gap a bit for a better torque down and dab a little Blu-Locktite on em?

 

[hotdog]

Link for the backing plate - template to make one up

 

[cleoncleon]

Thanks for that link, I remember seeing that once before, if i can find a means of making that I will, but till then, are there any cons to running it like this?

 

[hotdog]

HHB sells them - hit him up for a price for the backing plate - you want everything as central as possible to avoid the rotor picking up the stator & making minced meat of it.

 

[cleoncleon]

Makes sense..

Edit: Decided not to try and figure this one out..
Ordered a PMA swap from HHB.

 

[Punkskalar]

Good, you need to have a proper adapter and spacing to make the PMA fully functional. Thanks so much for your order.

your stator mount will bolt up to this plate...