so today i finally got a chance to mess with the fuel screws on my 79. first i turned them in to see how far out they were and they were about 6 turns out from the seat. i know that is way to far. but i turned it out another turn and the flat spot off of idle went away. so then i took the carbs off and took the top plate off to find out my snap ring pliers are not long enough to go into the slide any way. so now i have to wait until funds allow me to buy a couple main jets and a pilot jet or two and get a new pair of snap ring pliers. what a day. how far up should i go on the pilots and mains?