Sold / Found / Inactive - Good condition crank ready to install

[G_YamTech_314]

This is going to be my easiest and fastest option to getting this motor built and running before summer.

If anyone has a crank that has good rods, bearings, and all is there please let me know! My wrist pins had some major blue marks, and putting from spinning hot in the conrods... It's a sad day for sure, but I'm looking to replace this one, and rebuild it later.

Hoping to find a 447 crank. I'll do more research to find compatible cranks for my motor.

Thanks!

 

[member28833]

Have you investigated which years are a direct replacement for your 76 crankshaft?
idk..

 

[G_YamTech_314]

Not yet. I'll edit that I'm looking for a 447 crank. I read up a little bit that all the flywheels were the same? I need to do more looking.

 

[Jim]

Yes, all 447 motors used the same crank.

 

[Jan_P]

Well perhaps to late but I put it out here
If i Understand it right the pins are blue ..and have marks .
Are there excessive play in the hole with these blue ones inserted. ?
New pins are a fraction larger ( not worn , can be measured ) and reduces the play.
An Experienced mechanic can have a feel for if play is to large ..
The mech that examined mine put it like
" It is not new but I give it a OK " ( Was not Blue )
It was above expectations in engine sound afterwards.

It could perhaps be an alternative giving time for getting another .Or Rebuild one
Typical winter job If difficult find one now

here in Europe replacement exchange possibilities exist
https://www.xs650shop.de/en/crankcase/1008/crankshaft-447-at?number=39-5326

 

[G_YamTech_314]

I'm seeing what's our there for forum members first, if anyone in here has a 446 crank I'll take it. Otherwise, within the next few days, I'll be buying one on eBay

 

[grizld1]

Got one. PM sent.

 

[GLJ]

I'm seeing what's our there for forum members first,

Got one. PM sent.

If griz's parts are half as good as his advice you will get a good crank.