Keihin flatslide PWK carburetor cable fix

[RFLIVES]

Thanks Mr riggs for the idea here's my solution

Please forgive my " narration "

 

[Shickey]

Sent a pm to you. Need help with parts ordering.

 

[RFLIVES]

I suggest you turn those carbs in for scrap and get some vm34's however the run good and the cable is just sticking here you go.

All from 650central.com

Your going to need a 2-1 cable depending on the length and the adjusters,nuts and boots listed below


PART #'S

VM34 Round Slide Throttle Cable

2-1 to fit stock throttles

Throttle Cable for stock throttle, -7" (Daytona or Euro)

#FCEN26-4200..... $35.00

Throttle Cable for stock throttle (Pullbacks or Western)

#FCEN26-4100......$35.00

2-1 to fit Magura 314 throttles

Throttle Cable for stock throttle, -7" (Daytona or Euro)

#FCEN26-4310..... $32.00

Throttle Cable for stock throttle (Pullbacks or Western)

#FCEN26-4317......$32.00


CSUDmi002.61 Rubber boot x2
CUSDmi002.062 cable adj 6mmx.75 x2
CUSDmi002.065 Cable adj lock nut x2

 

[weekendrider]

Handy to know the options.
Thanks for the tips and product review.

 

[xjwmx]

From what I read the best way to fix these carbs is throw them off the Empire State Building.

 

[jacobbobber]

So I ordered this cable and these adjusters but the cable end won't go thru the adjuster to go Thru the spring to the plastic... I am tempted to shave them down some but I am afraid it will fuck with the plastic holding..... Any thoughts?

 

[jacobbobber]

Edit:nvm I was able to shave them enough to make it work

 

[slade]

I have run mikuni vm34 round slides for years, they are very crude and sometimes the slide gets hung up by engine vacuum and won’t return completely to idle (a common problem). I now use the chinese pwk 34 and they are far superior, no more problems and much easier to tune. Don’t let bias hinder your decisions.