Jaydela180
XS650 Addict
Recently purchased ultimate pamco with e advance(mikes part 14-0913) to replace stock tci ignition.
Wired as per instructions but no spark. Specifically, from e advance its red to switched power, green directly to coil and black to good ground. Engine cranks but no spark.
Are coil terminals specific when wiring pamco?
And also, when watching voltage drop on crank, volts drop to 10.5. Bad cell or normal drop?
Fyi all tci components and wiring were remived for pamco install.
Thanks in advance
Wired as per instructions but no spark. Specifically, from e advance its red to switched power, green directly to coil and black to good ground. Engine cranks but no spark.
Are coil terminals specific when wiring pamco?
And also, when watching voltage drop on crank, volts drop to 10.5. Bad cell or normal drop?
Fyi all tci components and wiring were remived for pamco install.
Thanks in advance