For Sale - Parts for sale

butthead13

XS650 Enthusiast
Messages
98
Reaction score
0
Points
6
Location
pleasanton,ca
I have a few part that I never ended up using so they are up for grabs.

75-81 Complete engine gasket kit $40 shipped

Lowbrow seat spring mount/perches light surface rust from just sitting around with 3" springs that I picked up from a swap they were spray painted black which I have removed so they are back to chrome $35 shipped

Monster craftsman clamp on skateboard wheel chain tensioner 1" was used for about 500miles I picked it up used and never used it $110 shipped

I also have a couple more parts if interested just no pics at this time but I can get them to you upon request.

-gas tank in good shape I small dent in the rear in primer no cap no rust
-gas tank in good shape with black paint no rust with gas cap and matching key believe its off of a 1982 heritage special
- tail light with grab bar
-used set of blinkers off the 82 heritage
- 1 plastic side cover black with heritage special emblem not sure which side at this time
- a swing arm with disk brake off of a 1980 I believe


email is best way to get ahold of me Dragula1376@yahoo.com if possible but I will do my best to get on the site to answer the messages too .


happy holiday to all.
 

Attachments

  • 20141224_170401.jpg
    20141224_170401.jpg
    55.2 KB · Views: 138
  • 20141224_170333.jpg
    20141224_170333.jpg
    66.7 KB · Views: 128
  • 20141224_170532.jpg
    20141224_170532.jpg
    81.3 KB · Views: 135
  • 20141224_170518.jpg
    20141224_170518.jpg
    60.4 KB · Views: 135
  • 20141224_170637.jpg
    20141224_170637.jpg
    163.1 KB · Views: 172
  • 215.jpg
    215.jpg
    126.4 KB · Views: 174
Last edited:
Bump up to the top ! I do take offers just no low balls! I have plenty of stuff I need to get rid of I just need some good time for a bunch of pics
 
I believe I have a disk mag complete and a drum mag only missing the center inner wheel spacer, in the attic. The spacer I have seen on bey a few times or someone on here maybe holding one or you can just make it with the right tooling and measurements
 
Back
Top