Torque specs for fork pinch bolts 77D

[XS650D]

I have researched this on the net and get conflicting numbers.
Can someone advise the torque specs for 1)Crown pinch bolt 2)upper fork pinch bolt
3)lower 2 pinch bolts (2 on each side) and is there a sequence for doing it.
Thx

 

[XSLeo]

My Clymer book Page 212 list those as
#1 not listed, this is the same size bolt as the upper fork pinch bolts, So it should get the same torque.
#2 7.23 ft.-lbs.
#3 14.5 ft.-lbs.
On the order I would snug the top enough to keep the tubes in place then snug the rest up then start at the lower bolts and torque them down then the top.
The crown pinch bolt snug then torque the crown nut then the pinch bolt.
Leo

 

[weekendrider]

Taken from the Yamaha SJ/SK service manual under Torque Spec.s
#1 Handle crown and steering shaft 8mm nut 8 ft. lbs. 9.8 Nm
You didn't ask but the
Handle crown and steering shaft 14mm bolt 39 ft lbs 53 Nm

 

[XS650D]

thx guys