I bought my bike without the carbs installed and purchased a set of rebuilt carbs, ready to be installed. So far, I have learned, that there is no room to fit the carb assembly in its bolted/screwed-together configuration. I took the manifolds off and fitted them to the carbs and even took the carb tops off, but still no joy. Before I go any further, what is the preferred method?
TIA and my Clymer manual and searching did not reveal the results I am looking for, and I apologize for asking an obvious question about what has surely been asked in the past.
TIA and my Clymer manual and searching did not reveal the results I am looking for, and I apologize for asking an obvious question about what has surely been asked in the past.