71XS1B Carbs Seals07 Using a valve as a guide and install tool. Sleeve driver made from aluminum round.
71XS1B #125Plate Both throttle plates measured 1.495" (37.97mm) across. This is 0.001" less than 38mm.
71XS1B Carbs Seals09 Sleeve pressed into place. Regular shaft seal fitted.
71XS1B Carbs Seals08 Brass sleeve fitted onto driver and valvestem. Press into place using thumb pressure.
71XS1B Carbs Seals07 Using a valve as a guide and install tool. Sleeve driver made from aluminum round.
71 BS38 Throttle Bushing10 Using the valve as the install tool, press the new bushing into place. Thumb pressure of only 10-15 lbs is used.
71 BS38 Throttle Bushing09 Use an old, clean valve as an installation tool. Slide an old bushing onto the valvestem, it'll be the press sleeve. Sli
71 BS38 Throttle Bushing08 Thin cut-off disc used to part off the excess 2mm.
TwoManyXS1Bs

71XS1B Carbs Seals07 Using a valve as a guide and install tool. Sleeve driver made from aluminum round.

There are no comments to display.

Media information

Album
1971 XS1B BS38 carburetor rebuild
Added by
TwoManyXS1Bs
Date added
View count
887
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top