IMG 12- The Doctor has made a clean extraction!
IMG 10 The first bit to be used (after applying the light coat of grease to the surrounding areas) was a 11/32 bit. Start slowly, only go in a 1/2 inc
IMG 11- Secondary 23/64 bit did not have to go in very far, maybe a 1/4 of an inch, before it grapped and I was able to work it out easily. If this bi
IMG 11B- Applying a light coat of grease to the surrounding area keeps shavings together, for an easier clean up.
IMG 12- The Doctor has made a clean extraction!
IMG 12A- Amazed to see the old bushing attach itself to the secondary bit used (23/64 bit)
IMG 13- Chamfer-a symmetrical sloping surface at an edge or corner. Or just grind the edge lightly and evenly to allow ease of rubber gasket installat
IMG 14- Light cleaning afterwards with a Dremel stainless steel brush.
YAM277

IMG 12- The Doctor has made a clean extraction!

There are no comments to display.

Media information

Album
Clutch Pushrod Shaft Bushing Replacement Pics
Added by
YAM277
Date added
View count
599
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top