Recent content by Chito

Thanks guys. Helpful as always. Not really looking forward to this. I like the shopping list ideas. It does make sense about not knowing for sure until you're in there.

Oh yeah... I just thought it'd be nice to have more standard format. I mean, beggars can't be choosers. I just hate getting into something and realizing I should have ordered something I hadn't even thought of.

There are some really great articles and how to's on here, but you know what might be helpful? Parts lists. Kinda how a recipe lists it's ingredients first before the directions. Example: I've got to change my cam chain guide. I'll need: 1. Cam chain guide 2. Gaskets or whatever else...

I should have said it starts stumbling at 3.5 and continues until the top of the range. I want to say it's not a problem, at least a whole lot less noticeable, if I'm not that hard on the gas. Problem is, if I go down a jet size on the main, all the way to stock, it's still there... just with...

So... 81. Bored 1 over. Stock everything. I was one up on the pilot jet. It had been wrecked. Put it back together. It Ran great for 4 or 5 years, but the exhaust was cracked and at some point that changed into an exhaust leak. I bought Mikes Commando system. After that it was really...

Loud and down on power, but fine really. I'm pretty sure my bike is mostly held together by sheer will and a little bit of magic.

Well, thanks for playing guys. I think I should probably check all the bolts on this motor. I checked the gaps, but it didn't occur to me to check to make sure the lock nut was tight. I've found a few missing parts and finger tight bolts too.

NoooOOooOooOoo! Funny I thought, that looks funny, oh there's where the chunk came from... then I forgot about it. Man. This bike has been killing me lately and I'm getting sloppy.

It is from the intake side.

Yeah. That seems about right.

Nope. Still starts great. Pings/clangs though. Sounds like it did when I had an exhaust leak a couple of years ago. A little down on power.

So... my bike motor needed some work. With no money in the budget, I decided to throw in a spare motor I had. I didn't know anything about it, except someone wasn't such a good painter. Valves were gapped correctly and still are. I went on a test ride and things were going great, until I...

Pm'ed you.

I see this is pretty old, but is it still available?

Hmmm... I checked and it does appear mine are both 6 pin, but they look like they're right. It also looks like one has a little snap hook and the other doesn't. I also labeled the connectors when I originally wired the new harness. Some of the labels are kind of worn off, but they seem to...