Recent content by ercwndt

I know this is a stretch but does anyone on here have any 35mm super narrow triple trees. Not brand picky! Let me know what you have!

How much?

Bump, looking for some decent ones of a runner.

Unfortunately I have already cleared that! Well, fortunately aand unfortunately since it is not working. :|

Hey yall! Having some issues with my bike and im having a more difficult time getting them worked out. At first I thought it was carb issues, then to find out it was an exhaust leak. Fixed that and im still not having the best of luck. I have BS34s on my bike with a Pamco ignition setup...

Looking for a good set of BS38 carbs. Let me know what you have! Pay or trades. Thanks!

I have a complete set of BS34 carbs as well as a set of carb bodies and several misc parts. Looking for get $80 for them shipped. Thanks!

I have a set of BS34s on my bike and I'm having an issue with them. When I adjust them to the proper float level the bike will not kick over. When they are adjusted a little deeper, the carb lightly trickle into the pods but the bike starts first kick every time. Trying to figure out...

Hey guys, i've been doing all the reading on carbs here and I cannot seem to find the answer to my question. I adjust my floats to the proper level and the bike won't kick over. If I adjust the float less than the 27mm then the bike will start but the carb will leak fuel out the back...

Flat broke, looking for a throttle cable and clutch cable...stock sizing. Let me know if you got something laying around. It's the last thing I need to get my bike on the road. Have a few things to trade, but not much. Thanks!

They are VERY similar to the Gordon Scott pipes!

Straight pipes, both kick out to the right side of the frame. Angled cut ends. Don't know much about it as I bought it used. I am selling it only because it will not work with my mids set up. It looks good and has been painted with high temp. Let me know if you are interested and I can...

Hey everyone, So I have a TC Bros hardtail on my 650 and I am getting to the final stages of mounting the rear wheel and chain. The stock chain pullers dont seem to want to line up with the hole in the axle plate on the hardtail itself. I know that you are supposed to shim the axle to work...

I got a TC Bros hardtail and rather than spacing out the axle with a bunch of washers, I was wondering if anyone has a pre '74 rear axle with the tensioners. From what I hear they fit with no washers needed. Can anyone shed some light on whether this is true or not and if so, sell me the rear...

After it goes to Milwaukee you can skip me as I was able to use a 3 jaw puller to pop mine off. Thanks again everyone!