Recent content by MrBillohnooo

I am 57, till tomorrow. Still riding the street tracker every chance I get!

Would be great to win something once. Just once!

Another of him not on a 650 though

There are some pretty good youtube videos of him doing what he does best! impressive!

Clean the pilot jets. Have had this happen after removing carb bowls to rejet. A tiny pc of crap in a pilot jet can mess with your day!

My Pamco has been working flawlessly for 3 years and 11000 miles now! I will be buying 2 more in the near future!

Nothing like a "duhh" moment! I have done it, and didn't think of it! Back to k.I.s.s. (keep it simple stupid) lol

I would use a mopar ignition resistor. Some of them are set in epoxy. These were used on 60s_70s Dodges, Chryslers etc. Get the one set in epoxy. It will reduce the voltage to about 8 to 9 volts. Leds will still be bright enough.

I don't spend a lot of time on here, but I will speak my mind. I agree if someone is being way out of control, pm them and ask em to pipe down some, and if they don't, report em to a mod. I like the general rules here about politics and religion. Arent racial slurs somewhat political (as in...

Yes, the advance rod

If its the kit with all the advance pcs, yes If your engine does not have the mechanical ignition advance on it, you will need the cross shaft, bushings and advance unit off of a 78 or earlier engine. The advance unit is under the small chrome cover on the top right hand side of the engine...

SR 500 fits well. Clears a lot of rear sets too!

Great lookin build! I agree with Jack about the Supertrapps!

I got the bird!!! Sam is a 11 yr old Orange wing Amazon Parrot. Quite the talker!

Although I didn't grow up in Texas, it still baffles me that it is only 10 miles difference from Amarillo, TX to St Louis, Missouri than it is from Amarilla (local slang) to Beaumont Texas. St Louis being farther.