Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Enjoy XS650.com?Consider making a donation to help support the site. XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
I switched them up all right
for future reference:
on the SSY500 Set
Bearing 25Y with Race 48YS goes in the top
Bearing 30Y with Race 48KS goes in the bottom.
Rick
I'm such a dummy.
I think I switched the races.
I'm using the
SSY500 bearings.
I installed one race in the top it sticks out of the top of the neck like (like others have reported) The number of the race I have left is 48YS.
Is that the correct one to go in the bottom?
Thanks in advance
Rick
Hey All:
I have a set of jugs with nice sleeves with broken fins and a set with good fins and notso good sleeves.
I would appreciate any tips on removing and installing sleeves.
TIA
Rick
I'm finally getting back to this and since I last posted I did discover that the push rod bushing was worn and the seal also leaked. I got around to replacing those parts this week. I went with the one piece rod. Took a short ride and, seeems to be working fine.
I pulled the sump filter...
Thanks Barb Bonnie and Gary:
Payment was made.
Its so very nice to do this. John's passion and ingenuity certainly made him worthy of this comeration.
It will be an honor to wear the patch.
Rick
Mikee's assisant:eek:
Now I've seen it all.
I guess when you are that messed up you might need some help messing up.
Man! : how messed up do you have to be to take that job:yikes:
It is turning into a stoner show with rich disfunctional people.
How could this be :confused:
Glad to learn...
I just recently became on the mission of making my SF into a desert sled. I can weld I just never did an exhaust. So I was looking into info into possibly doing it myself.
The bending part my be a hang up for me.
Can you buy 90 and 45 degree bends?
Just so I know what would it cost for you...
I would get an exhaust like on the Triumph TR6.
I do not know where to start.
Are there aftermarket ones for the 650?
Do they have to be fabricated?
If anyone has done this or know of a bike that has them; I would appreciate the info.
Rick
XS650SF
Hey John and all:
Its been a while but I think I would like to take a stab at this.
The lower clutch adjuster does wobble. Is this what you are talking about?
I looked in my Haynes manual for a for the push rod bushing and under the clutch outer drum the manual shows slide shim thrust...