Recent content by wickermann

I am looking for an XS650 camshaft sprocket that I can fit onto my XS-2 camshaft. I would prefer a complete camshaft so I can check alignment marks. Any old worn out / scrap camshaft will do so long as the sprocket is fine. Anybody help me out ??? Dave.

now all I need is an XS650 camshaft sprocket, anybody help me out, would prefer it in a camshaft, a worn out camshaft is fine as I wont be using it ?????

Has anyone here ever swapped over a camshaft sprocket? If so what is the best way to do it? Is it heat shrunk on? I have a 1972 XS-2 which I am converting to XS650 engine internals (533 crank, pistons etc) but I believe the XS-2 camshaft is better than the later cams, so I would like to keep it...

Bump, have a spacer just need an axle !!!!

do you have the rear wheel axle, nut and all spacers available? Regards, Dave.

Hello again, please help me, I need a rear wheel axle, nut and spacers to fit a 1981 XS650 with 16 inch mag alloy wheel with drum brake. Will pay shipping costs to UK. Thanks for looking. Dave.

thanks for that Leo. I have ordered some M4 x 10mm nylon screws from ebay. Cant wait to try it out.

yes, it is going fine. I have bought a weld-on hardtail for it, and I am waiting for it to arrive. I have lowered the front forks 2.5 inches. I am in the process of doing some electrics. I have made a 2-1 inlet manifold with a SU HS4 carb on it, I am having trouble getting that to run properly...

I have been searching this site for info on converting my 1972 XS-2 to a solid state regulator / rectifier. A used one came with my bike and I have started to install it. It has 7 wires coming out of it, 3 white, 1 thick red, 1 thick black, 1 green and 1 brown. I have been following a few...

where did you get that rear fender, I want one ????

I want it, is it the 298mm diameter disc? if it is can you tell me how much to post to England then I can pay you via paypal. Dave.

Sounds good, my email address is wickermann@btinternet.com Thanks, Dave.

hello again, I need a front brake disc for a 1981 XS650 front end. Can somebody help me? I am in England, will pay reasonable shipping costs. Thanks, Dave.

For sale or trade, a complete set of 1972 Yamaha XS-2 front forks, yokes / trees, headlamp mountings / shrouds, complete steering damper assembly. Fork tubes are pitted but the rest is in good order. Sell or Swap, what have you got ??? Parts are in the UK. Dave.

I would be very interested in the front forks and front brake caliper assembly. I am in England. Dave.