Search results

  1. savannah steve

    Rotor test. 4.7 ohms close enough?

    New brushes. All lights are LED including the headlamp .
  2. savannah steve

    Rotor test. 4.7 ohms close enough?

    Stock charging system, stock electronic ignition. Rode the xs about 14miles. Killed the battery. Charged the battery, 12.8 volts after sitting a week. Fire it up, 13.3 volts at the battery. Doesnt change with RPM. Tested the rotor, 4.7ohms. Battery is smallish advance auto parts 4L-BS...
  3. savannah steve

    For Sale - MOTOR and CARBS

    Gotcha and I understand . No worries .
  4. savannah steve

    For Sale - MOTOR and CARBS

    Dang. Anyone driving from Jersey to Florida? Need a motor. For my 81. I'll buy a harness from ya too.
  5. savannah steve

    1981 Carb issue...

    I don't post here much, and I'm a bit of a newb to the xs650 , but my bike did what you described : hiccup, run on one cylinder then both. One side black plug, the other tan. I found my battery wasn't fully charged. When I put it o a trickle charger, it ran great. I'm going to change...
  6. savannah steve

    Wanted - 1981 xs 650 engine.

    I have an 81 xs 650, but the engine smokes and makes noise. Looking to see if there is anyone in the Southeast That has a good engine to sell. I live in Lake Worth Florida . Sbussiusjr@gmail.com Thanks
  7. savannah steve

    Need help with simple light diagram

    My XS is almost Done! I am using the stock handlebar controls, and have relocated the ignition key switch to the lower right side of the bike. The battery is ina tray under the engine where the starter used to be. Im using the TC Bros chopper harness to make it run. Now, I need to wire the...
  8. savannah steve

    Free - XS650 Parts - Just Pay Shipping

    If the headlamp assy in complete and useable, I'll take it please
  9. savannah steve

    Free - XS650 Parts - Just Pay Shipping

    If the headlamp assy in complete and useable, I'll take it please
  10. savannah steve

    What have you done to your XS today?

    From a box o parts to cafe racer wanna be. Fired it today. Next, mount seat, lights, ride.
  11. savannah steve

    For Sale - Daddyg labor day week sale

    Hey Daddy, Looking for a good useable front caliper, throttle assy (actually looking for complete stock throttle / switch/ etc like on a facoty 81 cs special)
  12. savannah steve

    Swingarm Pivot Bolt too tight a fit into Bushing (swing arm Bolt tube)

    I had the same issue with the bolt and tube purchased from Mikes. I honed mine until the bolt was a snug fit. I used a small flex hone and alot of wd40. Got it from the mac tools guy.
  13. savannah steve

    For Sale - 81 xs650 part out.

    How much for the exhaust? shipped to 31322
  14. savannah steve

    For Sale - Parts for sale

    how much for the 2n1
  15. savannah steve

    The long haul

    I need rear shock brackets/ studs if you havent thrownthe rear section of the frame away.:shrug:
  16. savannah steve

    XS650 Swing Arm Bolt hole size?

    New guy here. Some awesome bikes here. Inspirational. I will be stealing ideas. I bought a '81 XS650 Special basket case. The PO warned me that the swingarm bot was seized. Soo, After heat, hammers, 20 ton presses, and alot of cussing, I cut the swingarm bolt to remove it. Now I...
  17. savannah steve

    Make Offer - Most items off an 1980 Special

    Are you selling the tank? How much shipped to Savannah, GA?
Back
Top