Search results

clearances seem fine between the two rotors. Once I tighten the screws it will not turn? Any advice?

First timer Rebuilding a 75b engine. following the thread along with a pile of manuals. have a couple of questions before I get ready to seal the cases. Any input would be helpful. 1. Does anything hold gear 4 on the shaft in the pic above? I looks like it could run up against the inside...

I am getting ready to start rebuilding my bottom end. Did a search and did not see any consensus on this... I am going to order the 5th gear and am wondering if I should do the full bearing set just to be safe? Is the quality on the mikes set good or is there a better alternative? Thanks as...

I have been staring at my frame for the last two weeks and cannot get this idea out of my head... It is always dangerous when you think you have come up with a good idea that you haven't seen anyone else do before. I like the Fong Bros style hardtails with the peg mounts included and it occurs...

Pulled apart an '81 in Brooklyn rather not get into shipping or making this a second career but don't want to scrap them if I can help it. tank Good seat no tears head light bucket w/ interior rut headlight ears battery box grab handle and sissy bar turn signals windshield mounts...

First post. I have been lurking and learning for about a year and finally decided it was time to get dirty. Bought a crusty Ebay engine planning on rebuilding it. its a 75 and seems to be complete. Not much other information given on ebay. The exterior is completely oxidized and the carbon...