Search results

  1. E

    PMA Battery

    Thanks, got one today waiting for it to charge. You must have some alert set for when you name pops up.
  2. E

    Engine turns only 90 degrees

    "and then left it on the sidestand for a winter. By spring the damage was done and it was parted out." Is this bad? Side stand all winter?
  3. E

    Bogs AT 4000rpm

    Got it. I will update soon.
  4. E

    Handlebar choke lever

    Thanks. That helps.
  5. E

    Bogs AT 4000rpm

    Is it OK to run the bike with the PMA disconected?
  6. E

    Handlebar choke lever

    My 83 handlebar choke lever fell off last night. I went back and found it on the road. I don't know what holds it on. must be a screw, but is there some kind of other piece that goes along with it. Anyone have an exploded diagram?
  7. E

    Bogs AT 4000rpm

    I do have the 2 into 1 header pipe
  8. E

    Clicking noise

    Loosened the chain a tad and the noise went away.
  9. E

    Clicking noise

    Hey, Just got the bike running after a few years so I will be posting a bit. Riding around today and i cut the engine in neutral as i entered the driveway. I heard a clicking sound. I recorded it and put on Youtube Happens when rolling both forward and back, clutch in or out. A little...
  10. E

    Bogs AT 4000rpm

    Around 14.5 Vots at 4000rpm Pamco Pete, that one. The newer version with out the coper. Using Battery
  11. E

    Bogs AT 4000rpm

    Hello, My bike sat for a year or two as I had no time. The last thing I did to it before i let it sit was I installed a PMA charging and Pamco. Also it used to have a dunstall exhaust with no baffle inside, essentially a straight pipe. Seemed to run ok. While doing the PMA and Pamco, I also...
  12. E

    For Sale - 83 XS650 For sale $2000 OBO Providence RI

    Hate to see it go, but don't have the time. Providence ri bike. New Hugh's Handbuilt PMA Brand New Pamco Pete. Have not ran it since upgrades. never finished. $2000 OBO Can be seen here http://providence.craigslist.org/mcy/5135526365.html 401-489-2239
  13. E

    Spark head scratcher

    What about just for testing with the hand spin method, not for actually running the bike. can i bypass the E-advance blu box in that instance? Many of the wiring diagrams even on thePamco site show the E-advance unit not in-line. Mind you, I am not running the bike this way, just testing with...
  14. E

    Spark head scratcher

    Double post by accident
  15. E

    Spark head scratcher

    both Edgewood and Njrmahoney are me, I have two computers and didn't notice that I have two accounts.
  16. E

    Spark head scratcher

    The switched wire red/white and the orange wire which are at my coil also run to the end of the tci plug, the half of the plug that stays behind after removing the TCI there is also a ground there. Here is the post by Pete himself http://www.xs650.com/forum/showthread.php?t=24434 It is...
  17. E

    Spark head scratcher

    After looking at some photos of the pamco plate and rotor, I noticed that my set up has the GREEN wire attached to the small board on the plate where it says RED, and th RED wire is attached to where it says GREEN. could this be the problem?
  18. E

    Spark head scratcher

    I would like to test the Pamco set up with a second battery, but I am a little unclear as to the procedure. I saw this posted by pete just get a spare battery and put it on the floor and hook up the PAMCO red wire to the positive terminal of the battery and ground the negative terminal of the...
  19. E

    Spark test

    Thanks JM
  20. E

    No spark on one side at low rpm's

    I figured that might be the problem, but when i swapped the plug leads it idles and runs fine, on both sides. so now I am thinking that i have a funky plug wire. Swapping it over may have improved its connection. What about pulling a plug lead while the engine is running, is it bad for the...
Back
Top