Hi
Haven't posted for a while, but was out for the first ride of the new year today and realised the list of jobs I wanted to do over the winter didn't get done. When I put the bike together I did the Brembo conversion and always intended to swap out the industrial rotors for something lighter and better looking. I bought the floating disc from Mike's XS but didn't pay attention that it only fits '77 onwards ( offset is much too small ).
So I've been looking around for options and came across ISR in Sweden who can be purchsed in the UK through bikehps.com. They provide a custom form with measurements required to put together a custom one off rotor. It don't expect it will be cheap, but without engineering spaces/brackets it might be my best route.
Before I haul the wheels off to break out the calipers, I wondered if anyone else has the measurements for the stock front and rear rotors ( mine earlier XS has a rear disc conversion ).
The form for the measurements is here a photo of my XS with the industrial rotors is below. Thanks in advance for any information.
https://www.bikehps.com/isr/ISR_Custom_Disc_Order_Form.pdf
Haven't posted for a while, but was out for the first ride of the new year today and realised the list of jobs I wanted to do over the winter didn't get done. When I put the bike together I did the Brembo conversion and always intended to swap out the industrial rotors for something lighter and better looking. I bought the floating disc from Mike's XS but didn't pay attention that it only fits '77 onwards ( offset is much too small ).
So I've been looking around for options and came across ISR in Sweden who can be purchsed in the UK through bikehps.com. They provide a custom form with measurements required to put together a custom one off rotor. It don't expect it will be cheap, but without engineering spaces/brackets it might be my best route.
Before I haul the wheels off to break out the calipers, I wondered if anyone else has the measurements for the stock front and rear rotors ( mine earlier XS has a rear disc conversion ).
The form for the measurements is here a photo of my XS with the industrial rotors is below. Thanks in advance for any information.
https://www.bikehps.com/isr/ISR_Custom_Disc_Order_Form.pdf