littlebill31
Smells of Raw Fuel
I should have done it when I thought about it, but noooooo, I waited.
I was doing a check and while removing the front brake master cylinder cover I snapped the head off of one of the bolts. I had planned to change them to stainless allen heads last time because the phillips slot was getting a little rounded. But I waited and this happened.
So my question to everyone is how to remove it? I bought new stainless M5 allen heads last night and changed 3, but the one that broke has broken a little less then flush with the reservoir, cover removed. There is nothing to grab the bolt with since it's down in there and I'm a little scared to drill because the reservoir is plastic. Buying a new reservoir is a little too pricey right now. Can I just use the 3 'till I can get a new one? Ideas?
Thanks all
I was doing a check and while removing the front brake master cylinder cover I snapped the head off of one of the bolts. I had planned to change them to stainless allen heads last time because the phillips slot was getting a little rounded. But I waited and this happened.
So my question to everyone is how to remove it? I bought new stainless M5 allen heads last night and changed 3, but the one that broke has broken a little less then flush with the reservoir, cover removed. There is nothing to grab the bolt with since it's down in there and I'm a little scared to drill because the reservoir is plastic. Buying a new reservoir is a little too pricey right now. Can I just use the 3 'till I can get a new one? Ideas?
Thanks all