Hey all, been spending way too much time on this site since I discovered it a few weeks ago... good people and some nice bikes. Here's mine.
- 34mm Mikuni round slide carburetors
- K&N pod filters
- updated oil filter
- aluminum intake runners
- aluminum FZ600 front fork with drilled and floating brake rotor and efficient ratio master cylinder
- braided stainless steel brake line
- 1.5″ exhaust headers with reverse cone mufflers
- bump stop solo seat
- Benelli tank
- aluminum clip ons
- new crank bearings, rods, pistons, rings, rebore, valves, valve guides, race cam, springs, cam chain
Going to swap out the seat for a bratstyle 'cause the wife wants to ride and I think it'll fit up to the tank nicer. (wish there was some way to keep both)
- 34mm Mikuni round slide carburetors
- K&N pod filters
- updated oil filter
- aluminum intake runners
- aluminum FZ600 front fork with drilled and floating brake rotor and efficient ratio master cylinder
- braided stainless steel brake line
- 1.5″ exhaust headers with reverse cone mufflers
- bump stop solo seat
- Benelli tank
- aluminum clip ons
- new crank bearings, rods, pistons, rings, rebore, valves, valve guides, race cam, springs, cam chain
Going to swap out the seat for a bratstyle 'cause the wife wants to ride and I think it'll fit up to the tank nicer. (wish there was some way to keep both)