I have seen links here on this forum about solutions and there are T parts to Buy
https://www.xs650shop.de/en/carb-mikuni-bs-34/840/brass-fuel-line-t-piece/bs-34
But the carburetors are difficult to separate.. Right JIS bit and Right tools .
Clamping the carburetors down
I have tried twice not getting them off. Without
Ending in drilling and a lot of Work.
I am a bit of " Quick Fix " Low budget getting it to run.Person I would most likely try to smear some
Gasket forming chemical on the outside. Se what happens. Rubber can benefit of some gas on it again sometimes
But if the bike has been sitting .The Experienced gentlemen here
Dont even want a start attempt to happen. Because old gas would clog the carburetor.
But speaking for myself .I would perhaps try it.
The float bowls can be taken down carbs still on the bike .And if that is not bad.
I would be tempted to try a start up. Se what happens .But again Many here will probably Protest.
I also matters what is going on here .If it is a full restoration then a tear down will happen
But if it is something for a run to the roadside Cafe and back tomorrow it can be a different situation.
I also happen to Know that people here likes Pictures
.
.