Wanted - clutch plates to make clutch holder

[xjwmx]

No longer needed. I was able to get 'er done by laying a wrench across the swing arm to block the mag rear wheel from turning. Let's see you do that with spokes!

 

[DogBunny]

PM sent...

 

[xjwmx]

^ Too expensive. I could get a part of new ones for around $13 if I move up my next Mike's order.

 

[fellfrosch7]

Or you can get the actual tool from MikesXS for $9...part 35-5021

 

[xjwmx]

^the tool is reportedly too bendy to use.

But anyway, I was able to get 'er done by laying a wrench across the swing arm to block the mag rear wheel from turning. Let's see you do that with spokes!

 

[fellfrosch7]

Did not know that about the tool, thanks for the tip.

A friend of mine was trying to loosen a clutch nut on a scooter (CVT trans) recently, did the breaker bar on wheel trick too. Except he just happened to put it where the valve stem is, so that snapped in half pretty quickly.

 

[xjwmx]

Ouch. With luck like that I wouldn't be living near Vegas!