Grinding a carb slide cutaway...

[LPYYZ]

Here was today’s set up...

MJ: 190
PJ: 22.5
NJ: P6
JN: 6F9 3rd slot
Slide: 2.0
Air Screw: 2 turns out

I’ll see how the plugs look once I get out on the bike this week.

 

[gggGary]

Been thrashing on madness, a cammed probably port worked Bob Berault built 750 with VM34's, big K&N filters 1 3/4" headers into some free flowing borlas. Accel coil fired by a E-advance pamco.

Carb: VM34
MJ: 210
PJ: 25
NJ: 159-P6
JN: 6F9, 4th slot
Slide: 2.5
Air jet: ?
idle screw 1 turn out.
Float valve 3.3
Just a few miles on it like this so far will put on over 100 today. so far plugs are looking like it's close.