hardtail,,,standard width 18"

[oldbiker]

hi guys does anybody in the state make up a pre-welded rigid rear for a 76mod ... rear that fits a 18" wheel with standard tyres,,, i.e. 120x 18... eg .. all welded and boxed to send to australia... ,,i want 1 that follows sought off the line of the back bone,,, not stepped down regards oldbiker

 

[deacon883]

I like the unit produced by G&L Choppers in Colorado. Well made and not too pricey.

 

[deacon883]

http://www.freewebs.com/glchoppers/

 

[Ghetto]

Good luck. I tried ordering 2 tails off them a while ago with no luck!

 

[cros36]

G&L has to do something about them dropouts. IMO.

 

[Ghetto]

That's what makes them different though. I always wanted a G&L tail because of them but the more I waited and looked at them I switched and went with Elswick.

 

[lukach4]

I tired contacting them a bunch of times. No answer... left messages... no response.. Done with them...

 

[Ironsled77]

I got a tail from them before the xs craze. It was a pain in the ass dealing with them then took lime 4 months and it was winter. The tail was top quality and 10 fold over tcbros. If I had to do it again I would go with David bird.

Posted via Mobile

 

[Ironsled77]

Oh and for the original question I think all the tails will fit an 18. I know I could fit a 21inch on the gl

Posted via Mobile