Yep pekka there really isn't much to it if you are doing a one off and are not too worried about alignment. You need to get the pushrod material (I use Hardened Stainless 8mm precision ground rod - $40 for 6') You need to get mounting screws, slave cylinder, banjo/bleeder bolt, etc etc etc. There are a good bit of parts to source but I have done all of the leg work and am selling these in either 1 of 2 flavors. 1 is with me doing the machining on the covers and supplying all of the needed parts or 2 I supply the needed parts and you do the machining. Prices for both flavors are up in my shops post.