Going through the right side carb I have found that the float level is at 26.16 millimeters, is there any reason they would be set that high? After looking through the tech section I have found guides that says it should be 24 and one that says 25, Which one should I shoot for? I am measuring with the gasket removed. Also I have attached a picture of the carb, I'm not having any luck identifying the hole on the top left by the butterfly and it's the only one I can hit with carb cleaner or air and can't find it coming out someplace else. I don't think it's a blind hole because if I pool a little carb cleaner on it there's a slow bubble that comes from it. Thanks again everyone for your help and patience!