Ok quick clutch question. Pulled the right side cover off and watch my pressure plate, clutch felt fine. I just pulled the clutch apart to check the washers, and put everything back together right... Now I'm pulling the clutch lever and getting absolutely no pressure at all. Just pulls right back to the handle. I'm guessing this isn't normal?
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Quick question.
- Thread starter OldGuy
- Start date
Kingwj
I know nothing, nothing!
Did you put the ball bearings back in?
There is one in the worm actuator and I believe another between the 2 rods, unless you have a one piece rod.
There is one in the worm actuator and I believe another between the 2 rods, unless you have a one piece rod.
I never removed ball bearings or rods. Just pulled the clutch plates and the center to check the order of washers. I never even saw the rod?
