For Sale - rear loops and featherbeds

[billyfly1]

rear loops, custom made for your cafe project, made to your specs...1 inch or 7/8 inch dom...65.00 plus shipping... pm me specs...

also slimline featherbed starter frame...newly made slimline type featherbed frame ...tig welded 1.25 X .120 wall DOM mild steel...great start for your project...weighs approximately 35lbs... head tube installed with 30205 bearings also comes with swing arm plates and rear shock mounts not installed... 800.00 plus shipping domestic only from 19468
box size is 36x36x12 approx. 35 lbs.. we can also make head tube to your bearings and length...

 

[billyfly1]

bump it up

 

[durgam_K]

Im very intrigued by this!!!
What are some of the widths, and fitments your thinking???
Did you design it around a motor specifically?

 

[billyfly1]

Im very intrigued by this!!!
What are some of the widths, and fitments your thinking???
Did you design it around a motor specifically?

you have 7.5inches in between back of main loops
19 inches from top of bottom tube to bottom of top tube
9.625 inches between top rails at widest point
i am putting a triumph pre unit in one now but this frame is made from a 1966 atlas slimline original ..measured with a computer base measuring devise ..so any engine you see in one of those will fit this frame...naked frame also allows placement of however you want to do mounts and tabs ...hope this helps.....billy

 

[billyfly1]

bump it up

 

[SteveH]

Looks awesome - glad you're right around the corner ! Might need to hook up with you on some cafe items over the winter...

 

[billyfly1]

Looks awesome - glad you're right around the corner ! Might need to hook up with you on some cafe items over the winter...

I'm here whenever you want....billy

 

[billyfly1]

bump it up

 

[billyfly1]

back up top

 

[billyfly1]

to the top

 

[billyfly1]

again to top

 

[billyfly1]

back it up

 

[billyfly1]

bump it up

 

[billyfly1]

back to top