Starter was working.

[Ccrider]

1975 rebuild. Stock wire harness. New Pamco, new coil.
Just got everything back together, started with elec start a few times.
System seems to be working well. Then-
Was going to check ignition timing, but now elec start quit working.
Checked the one fuse, and it was blown. Replaced fuse, tried Elec start and still nothing.
New fuse checks good ? Bike is in neutral. Off/on switch on, key on.
Why would it just quit woRking ?

 

[yamaman]

a common problem is the earth, try putting a jumper cable from your bars to a good earth point.

Posted via Mobile