Ok so i recently put in a 750 kit and performance cam and valve springs... ... the dang thing didnt smoke before but now it has white smoke from the exhaust only on start up, once it warms up it goes away.
I dont understand why the valve guides are acting up now after the motor is all together... ... the cam and valve spring set from mikes came with new valve stem seals which i put on so they are new too... the only thing not new are the valve guides... but they were fine before the rebuild...
Why NOW?.?.? any advice short of pulling the head off and replacing them?
so far ive double checked my valve clearances and with a screw driver cafefully made sure the valve stem seal is seated properly. smoke only comes out on the left side btw
I dont understand why the valve guides are acting up now after the motor is all together... ... the cam and valve spring set from mikes came with new valve stem seals which i put on so they are new too... the only thing not new are the valve guides... but they were fine before the rebuild...
Why NOW?.?.? any advice short of pulling the head off and replacing them?
so far ive double checked my valve clearances and with a screw driver cafefully made sure the valve stem seal is seated properly. smoke only comes out on the left side btw