Leejin
XS650 Enthusiast
Hello everyone.
I have a Stock Charging system, with a Pamco and starter.
This is the closest diagram I could find, but I can't figure out how to wire the 4-Point Ignition.
Here is a similar 4 Point Ignition Switch I'm using. So it's like a car/boat.. It turns once to "On", then turn past to start, release it goes back to "On".
My trouble is; It will only turn over in between the "On" position.
I have the brown wire from the regulator going to a fuse box, where I have a 7.5A Fuse going to the pamco, and the coil.
Any help would be great.
Thanks again.
I have a Stock Charging system, with a Pamco and starter.
This is the closest diagram I could find, but I can't figure out how to wire the 4-Point Ignition.
Here is a similar 4 Point Ignition Switch I'm using. So it's like a car/boat.. It turns once to "On", then turn past to start, release it goes back to "On".
My trouble is; It will only turn over in between the "On" position.
I have the brown wire from the regulator going to a fuse box, where I have a 7.5A Fuse going to the pamco, and the coil.
Any help would be great.
Thanks again.