I have a XS2 starter that needs to have its long screws replaced. The screws that hold the starter body together, that is.
They are not available to buy so i must make them.
The starter is in a remote location so i cannot measure anything from where i am now.
A straightforward solution would be to weld or braze a suitable screw head to a piece of threaded bar and then grind away the threads in the mid section to provide clearance from the armature.
Does anybody know the length and thread of these? M5 i suppose but i am not 100% sure.
They are not available to buy so i must make them.
The starter is in a remote location so i cannot measure anything from where i am now.
A straightforward solution would be to weld or braze a suitable screw head to a piece of threaded bar and then grind away the threads in the mid section to provide clearance from the armature.
Does anybody know the length and thread of these? M5 i suppose but i am not 100% sure.