71 BS38 ThrBush03 After about 1/2 turn, the bushing will spin in its bore. Continue to slowly turn and withdraw the old bushing.
71 BS38 ThrBush06 Bushing part number. Either 8H 1A, or 8K 1A. 10mm OD, 8mm ID, 8mm long.
71 BS38 ThrBush05 Manufacturer logo on bushing wall.
71 BS38 ThrBush04 The bushing appears to be a split-type, steel-backed, bronze-core, plastic-lined.
71 BS38 ThrBush03 After about 1/2 turn, the bushing will spin in its bore. Continue to slowly turn and withdraw the old bushing.
71 BS38 ThrBush02 Use a sharp 3/8-16 NC tap.
71 BS38 ThrBush01 There's very little room behind the throttle shaft bushing.
WarpedBase10 Wax chip is completely squeezed down to level of gasket ridges, indicating that the gasket should seal in this critical central area.
TwoManyXS1Bs

71 BS38 ThrBush03 After about 1/2 turn, the bushing will spin in its bore. Continue to slowly turn and withdraw the old bushing.

There are no comments to display.

Media information

Album
1971 XS1B BS38 carburetor rebuild
Added by
TwoManyXS1Bs
Date added
View count
897
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top