As part of the weight loss program, I removed all of this stuff. I figure that the kick start will do it and if it won't, I probably shouldn't be tryi
When I tore into the engine, I found that the front guide for the cam chain had lost the plastic shoe and it had fallen down into the crank case, allo
When I replaced the little cover that goes over the part of the tranny where the electric starter gears are (were), I used a couple of wire guide/clam
When I removed the starter, I installed this freeze plug (obtained from a local auto parts store) to block the hole. I tapped it in from the inside of
As part of the weight loss program, I removed all of this stuff. I figure that the kick start will do it and if it won't, I probably shouldn't be tryi
Top triple clamp was originally a sort of ugly flat black, so I blasted all that off, did a little sanding and then coated it with clear. Personally,
The frame and misc parts all done....you can see the rattle cans we used to do the paint. I had a local automotive paint shop (Barrett's) here in Reno
The Austin Tan applied to the frame, but before the clear coat was applied.
D

As part of the weight loss program, I removed all of this stuff. I figure that the kick start will do it and if it won't, I probably shouldn't be tryi

There are no comments to display.

Media information

Album
Winter XS650 Street Tracker Project process
Added by
dondlhmn
Date added
View count
491
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top