Top triple clamp was originally a sort of ugly flat black, so I blasted all that off, did a little sanding and then coated it with clear. Personally,
When I replaced the little cover that goes over the part of the tranny where the electric starter gears are (were), I used a couple of wire guide/clam
When I removed the starter, I installed this freeze plug (obtained from a local auto parts store) to block the hole. I tapped it in from the inside of
As part of the weight loss program, I removed all of this stuff. I figure that the kick start will do it and if it won't, I probably shouldn't be tryi
Top triple clamp was originally a sort of ugly flat black, so I blasted all that off, did a little sanding and then coated it with clear. Personally,
The frame and misc parts all done....you can see the rattle cans we used to do the paint. I had a local automotive paint shop (Barrett's) here in Reno
The Austin Tan applied to the frame, but before the clear coat was applied.
Applying the self etching primer to the frame and misc. parts.
D

Top triple clamp was originally a sort of ugly flat black, so I blasted all that off, did a little sanding and then coated it with clear. Personally,

There are no comments to display.

Media information

Album
Winter XS650 Street Tracker Project process
Added by
dondlhmn
Date added
View count
477
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top