Recent content by blackbetty

Risers are sold

7/8" 4" rise NOS vintage alloy Stainless steel hardware comes with a riser crossbar. $60 shipped

7/8" Total 24.25" wide 4" tall 6" inside Pull back 1.5" raw steel Has a roll pin installed for a Barnett throttle. Just pull it if you're using something different. $65 shipped

hahahaha Classic

Nice progress. Where about in Dallas? Lemme know if you need a hand w anything

Here ya go....looking outstanding amigo I love this pic

remove...

A little dirt helps w break in right?

SICK pipes

Absolutely filthy....godspeed on this thing...I'm going to post up a few of your pics bc visiting the albums is a pain

Thanks for the heads up griz.

You guys remember me? Checking in after a long hiatus since I've been busy building other bikes and doing stuff. Here's my 75 along w my buddy and his sweetass 69 BSA Firebird. My xs has been in sitting listlessly in the corner of my garage for about 8 months, and I finally had some...

Damn dude that roller setup is RAD, this thing is gonna scream

It's probably the #1 mod you can make to increase reliability.

Nah I'd been running it already for a couple hundred miles. Didn't bother though I'm sure Hugh would've been helpful.