Recent content by Rexxis

  1. Rexxis

    Pamco advance rod slop, is this normal?

    I will check it this evening and let ya know what I find. Thanks Pete.
  2. Rexxis

    Pamco advance rod slop, is this normal?

    Ok, good. Jus makin' sure.
  3. Rexxis

    Pamco advance rod slop, is this normal?

    This is my second time installing my Pamco setup, I'm just wrapping up after replacing my valve seals. I never noticed it the first time but now, with everything tightened up, my advance rod slides laterally abt 1/16". Is this normal? To clarify, if I'm sitting eye level to the side of the...
  4. Rexxis

    running way rich, Ive hit a wall.

    Okay, okay. Cool
  5. Rexxis

    running way rich, Ive hit a wall.

    How did you determine you had weak spark? Sorry, I know very little abt the electronics side of the bikes.
  6. Rexxis

    Bike runs good until it's warmed up, then terrible

    Well, I got super lucky. Once I pulled the head off the bolt WAS sticking up past the surface of the cylinders, abt 1/8". This was just enough for me to get a good grip w a pair of vice grips. The bolt spun out no problem. WHEW!! That could have been so much worse.. I had planned...
  7. Rexxis

    Steps for replacing the valve stem seals ?

    Oh, ok. Gotcha
  8. Rexxis

    Bike runs good until it's warmed up, then terrible

    It's almost freezing today so I won't be out in the shop, I plan on pulling everything apart again tomorrow. New head gasket should be here Thursday so maybe we can start moving forward again this coming weekend. Holy shit, look at this. Replacing valve seals through the tappet covers while...
  9. Rexxis

    Steps for replacing the valve stem seals ?

    Pushrod seal? Am I missing something? I would like to know what seals you are referring to though bc, my top end is apart right now, I just replaced my valve seals. Are there other seals on the top end besides camshaft seals, that I am unaware of?
  10. Rexxis

    running way rich, Ive hit a wall.

    Hit them with some penetrant and let them sit. If they still wont come out, you can try this, just be careful. Taken from http://www.amckayltd.com/carbguide.pdf
  11. Rexxis

    running way rich, Ive hit a wall.

    Idling up on its own is sometimes indicative of an air leak. Spray carb cleaner around the carb boots, butterfly shafts and around the choke plates. Listen for changes in rpms. It can take a second sometimes to get a response so remember to wait a good 5 seconds or so between squirts.
  12. Rexxis

    Bike runs good until it's warmed up, then terrible

    You're right. I screwed up when looking at this. FML
  13. Rexxis

    Bike runs good until it's warmed up, then terrible

    I will post pics tomorrow after work. I have to step away from it for tonight. Thanks you guys so much.
  14. Rexxis

    Bike runs good until it's warmed up, then terrible

    Yes it is. About and inch or more down in there.
  15. Rexxis

    Bike runs good until it's warmed up, then terrible

    eBay Now I know I messed up. Bigtime. Snapped the little bolt at the back of the head. The rest of it is in the cylinder block. Yes I was using a torque wrench set at 16 ft/lbs. What do I do?
See more
Back
Top