Search results

  1. H

    1983 Model-attached is engine number

    I have and 83 Engine number: 5V4-100546 What is the model? Thank you Chris How do you find it also-I also have two 81's
  2. H

    Oil after valve adjustment

    I have an 83, I adjusted the valves and after that left cylinder started blowing oil when I started the bike-I used .006 for the exhaust and .003 for intake. It is really blowing oil from that side. Cylinder plug is also wet with oil-what could have caused this, what is wrong. ?? Chris
  3. H

    1/4 ball bearing location

    I took off the outside cover to change my alternator and a 1/4 bearing fell out-where does it go?
  4. H

    New Boyer ignition wiring help

    I have a 83 650 chopper-it only has rear light and high and low beam -it has toggle switch for on and off, can I get some help wiring this to the new boyer?
  5. H

    Simple wire diagram

    I am getting a boyer electronic ignistion for for my 83 chopper. It has only a front light control by a toggle switch and rear brake controled by the pedal switch. The ignistion switch is a toggle switch-turn on and kick start. I want to remove it all the replace so it looks decent and not...
  6. H

    Valve Clearance

    I have an 83 xs 650, what is the intake and exhause valve clearance? Thanks Chris
  7. H

    Compression test

    My 83 is running ok, the right cylinder seems colder and not as hot as the left. I used new jets, 45 and 140 from 650 central-I did a compression test on the right cylinder the one that is running colder than left-I got a consistant 75psi-when I rev'd the engine it went up to 125-is that ok...
  8. H

    Charging system

    My bike is not charging the battery-just started. How can I check to see if it is the altenator or retifier? I have never none this before so if you can be specific it will help me. I do have a volt meter. Thanks Chris
  9. H

    Carborator gas tee

    When you replace the gas tee is their some type of o ring washers that make the seal? Who sells a replacement gas tee with whatever makes it seal between carbs Thanks Chris
  10. H

    Idle Jet rubber seal

    If the idle jet rubber seal is bad is it ok to use silicone to seal the top of jet idle jet screw?
  11. H

    Backfire right side cylinder help

    Need help with my 83 xs650 backfiring on right side-it starts first kick always, when I roll on the throttle I get backfire, let off and it stops, then roll on again and it acts like the cylinder comes alive and you here the pipes-almost like it was not firing-It has spark and I added the mikes...
Back
Top