Search results

I tested my coil following Pete's instructions. In step 5 (outlined below) I measured 25K ohms. Should be 15-20K. Is my coil good or bad? Not sure if there is a tolerance here or not. Testing the coil: 1. Using the lowest scale on the meter, measure the resistance between the primary...

May sound stupid... do these engines fire at TDC? :shrug: I did a banshee swap and don't have a reference point other than TDC to set my timing... :er:

Just finished putting my top end back together only to read on a post that the valve springs have a top and bottom? Anyone ever accidentally run one upside down? Really not looking forward to reversing all my work...... :doh:

I have read a million different things on which oil to use. But no clear cut answer. Can someone list what they're using in simple terms? Thanks!!

Anyone know if the stock throttle cable fits into a Magura Straight Pull (314) throttle assembly? I am using a 2 into 1 cable from Mikes.

Hey guys, I have a hardtailed framed (TC Bros) and was hoping someone would know what length of chain (number of links) I would need? Any help appreciated!

I read somewhere of guys using scotch brite (I think) to give a brushed look to their side casings... how do I go about this? Just start attacking it with the scotch brite?

I would like a low sitting tank (def not frisco style), Sporty is way over done IMO. Wassell is freaking expensive.... the last one I watched on ebay went for $400!! Some sort of high tunnel peanut tank. Any suggestions where to look or perhaps an old model I am unfamiliar with? Thanks...

I am on a hunt for a electrical box/can. Can't really justify $100 for one when I can adapt with something else. Does anyone know a generic dimension for one of the round can styled ones? Just want to make sure I can put everything in there! Any help is appreciated.

I read elsewhere that if you run a kick only setup you can use a considerably smaller battery. Can anyone else verify this? Or have experience with it?

Hey all, doing a project on an 81'. MikesXS doesn't have stock for the Pamco TCI conversion on their Canadian site. From what I see I can't order off the US site. Is there any other vendor? Thanks!!