Search results

Thanks Jack,Looking forward to it!!

8, member: 301"]Is that 2 /1` cable made to work with flatsides? The cable needs to be installed with spring to the slide. Even with single cables,they're a bear to install. With the flow capacity of the flats,I hope you addressed the head to increase it's flow capacity. Jack thanks for the...

I just bought a set of Mikuni TM36 flat side carbs,having a bit of a drama fitting the cables,should I fit the cables to the carbs first then join the 2 into 1 cables on the quick action throttle or the other way around.At first I connected the cables to the carbs but couldn't join the cables...

Thanks mate I'll have a look

Thanks mate

Ok I'll check it out

Littlebill thanks mate,Thats sounds like the easiest way out,cheers

Has anyone got idea's on how to mount the green coils from mikes 277 pma ignition system.Looks like it won't fit strait to the frame,is there a bracket? I'm up for any ideas. cheers Whitey

Hi,Im hoping someone might be able to help,I bought a Pma system from Mikesxs and I'm having trouble fixing the big green coils to the frame,Has anyone had problems with them,none of the mounting holes line up and seems a bit to large for the mounting holes under the tank,Im sure there is a...

Ok thanks for the advice , the top race is sitting about 3mm outside the frame? but doesn't feel like it will go down Mate I might try and tap the top race down a bit more its sitting a bit proud of the frame,I'll let you know how I go.Thanks for that link,great info in it.cheers

I have a problem with the steering head,I just fitted new races and bearings,and tighten everything up and found I have a 5mm gap between the stem and crown,pretty sure it wasn't like that when I pulled it apart. The races are in as far as I could get them without damaging them.All ways...

Thanks mate

Thanks for the tip ,I'll give it a go.I hope I have returned this message correctly, First time so I hope I'm doing it right="whitey, posI'll 474948, member: 24572"]I could do with a bit of advice on replacing the steering head cups,The bottom on is very tight,would it be ok to heat the race...

I could do with a bit of advice on replacing the steering head cups,The bottom on is very tight,would it be ok to heat the race before to get it to go in a little easier , or just tap away until it goes in? Also is it ok to put the races in before powdercoating,.