Search results

Hey Guys! I have for sale a never been run 21" 60 spoke chrome front rim and Avon Venom-X 80/90-21 tire combo. They came with the springer that I also have listed for sale and are in new but not prefect condition. There are some little rust spots showing up on the spokes an hub but it is...

Hey All, Earlier this year I picked up this springer with the intentions of using it for a later build but plans have changed. It is the springer from the TC Bros kit found here. It has not been run, but has been sitting in a damp garage for too long. I bought it as it is now, with minor...

Hey guys, looking for the rear wheel bearing spacer, flange, & collar for a dics brake mag wheel. Part numbers are: 2M0-25317-00-00 - SPACER 2H7-25315-00-00 - FLANGE 90387-20166-00 - COLLAR (256-25376-00) They are reference numbers 4, 5, & 6 on the attached diagram. Let me know if you...

Hey guys, here are a few more things that I am not in need of. Let me know if you need more pictures or info! Daiichi Contact sets (x2), they are stamped with "DH-40" - $20 for both sets: Set of BS34 carbs from a 1980 special (2F0 prefix). They are in good shape just dirty and appear...

I recently bought a bike that had some new parts with it that I am not going to use. These are new and never run although they have been installed. The mufflers have a few nicks from where they were hitting the frame and a dent from where the center stand contacted them. The marks are all on...

Hey guys, just a few things a need for my 1979 special build: - Stock rear axle and nut - Drive chain adjusters - Swing arm bushing sleeve that will work with new brass bushings Any help is appreciated! Thanks!

I picked up this set of forks a while back for my build and didn't notice at the time, but they seem to be a little different. They have a little sticker on the bottom saying KYB and appear to have some adjustment that I do not believe is stock. They are 35mm and the trees seem to be stock as...

Hey guys, Long before I was a member, I was one of the guys lurking in the background wishing I had a XS of my own. This sites tech resources and amazing members have been hugely inspiring, not only get my own project finally rolling, but also to encourage me to pursue my ideal career. I have...

So I have been wanting to go to a PMA system when my engine is back together but was wondering if it caused more (or any) of a drag load on the engine? Since the PMA has permanent magnets (obviously), and they will always induce a voltage into the stator windings when it is rotated, does that...

I am in need of a complete mag wheel front end. Triple tree, forks, mag wheel, rotor, caliper, axle, and all the bits that go with it. I do not need a handle bar or any of the things that go on it, nor do I care if the bearing are trashed since I plan to replace them anyway. I also do not need...

After months of working on other projects and being distracted by lots of things that life has thrown at me, it is finally time to begin my build! My basic plan of attack is to keep it as simple as possible while drawing a lot of my inspiration from trackers and some cafe styling. I plan to...