angus67
Welder's penetrate deeper!!
So I'm slowly getting together a gt380. I've got copper base gaskets, and head gaskets. I have been looking for torque specs for the head nuts. I know many of you have worked in garages and dealers thru the seventies and saw a few of these 2 strokes pass thru.
I'm tempted to go to 25ft/lbs. Seems a average for nut on studs, steel sleeves. It's a alum block, alum head, just like our xs650. I'm targeting low, that way if there is issue, I can snug up to 30#s.
Even the manual doesn't say.
Thanks in advance.
I'm tempted to go to 25ft/lbs. Seems a average for nut on studs, steel sleeves. It's a alum block, alum head, just like our xs650. I'm targeting low, that way if there is issue, I can snug up to 30#s.
Even the manual doesn't say.
Thanks in advance.