Satch39
XS650 Addict
Hey all,
I've been around for a bit, but haven't posted a whole lot. I've done some business with quite a few members. This is my first thread.
So to get down to it, I bought a set of 78mm cast pistons out of Japan, on eBay. When I took them to the machine shop I'm using, the machinist asked me if there was a recommended over bore for the cast piston vs. a forged piston. Does anyone have any recommendations on this? I tried emailing the seller, but I didn't get an answer. Any help would be appreciated.
Thanks
Satch
I've been around for a bit, but haven't posted a whole lot. I've done some business with quite a few members. This is my first thread.
So to get down to it, I bought a set of 78mm cast pistons out of Japan, on eBay. When I took them to the machine shop I'm using, the machinist asked me if there was a recommended over bore for the cast piston vs. a forged piston. Does anyone have any recommendations on this? I tried emailing the seller, but I didn't get an answer. Any help would be appreciated.
Thanks
Satch