wymondham1979
XS650 Enthusiast
The bike was a little finicky to get into gear so it took off the side panel and found the worm gear housing was broken and the previous owner was using a bolt to push the clutch rod after reading various threads on this forum measured the distance from casing to end of push rod 1-10/16 so she was missing the 5-16 internal ball bearing(both balls really)
I bought a new clutch pushrod ,ball ,worm gear, cable and put them on the problem I have is the cable appears too short with the adjusters all the way in if I connect the cable to the worm it pushes it out so I can't get the cover on
Am I missing something really simple or am I being really simple LOL
Many Thanks
also does the pushrod actally go into the worm? as the thinner part dosent on my worm
I bought a new clutch pushrod ,ball ,worm gear, cable and put them on the problem I have is the cable appears too short with the adjusters all the way in if I connect the cable to the worm it pushes it out so I can't get the cover on
Am I missing something really simple or am I being really simple LOL
Many Thanks
also does the pushrod actally go into the worm? as the thinner part dosent on my worm