Uglies
XS650 Enthusiast
Can I install My PMA Without a Torch Wrench? and if so how`s it done?
Hi Uglies,
you don't mean a gas-axe, eh? Negatory hot wrench on that job for sure.
Lacking a torque wrench, bear down on it with a 3/8" square drive ratchet wrench just hard enough that you grunt. Bearing down until you break wind is too much.
A Foot Pound is like putting 1 pound on the end of a foot long breaker bar. Measure out about 1 foot on a breaker bar and mark it. put the socket on the breaker bar and put it on the nut. Hang a 5 gallon bucket at the mark.
Fill the bucket with 25-28 lbs. of something, water weighs 1 lb. per pint. Add 25-28 pints of water to the bucket.
This gives you 25-28 ft./lbs. of torque.
Leo
Hi Uglies,
you don't mean a gas-axe, eh? Negatory hot wrench on that job for sure.
Lacking a torque wrench, bear down on it with a 3/8" square drive ratchet wrench just hard enough that you grunt. Bearing down until you break wind is too much.
Yea and the scale would be............If your.........
100lbs 3 farts
150 lbs 2 farts,
200 lbs 2 grunts,
250 lbs...........lose some weight
Funny stuff! It's like measuring with c$&t hairs. These old school guys have told me this a few times. Exactly how thick is a chicks hair? I've never been with a woman with hair downstairs so when someone tells me a c$&t hair, I'm lost. Lol