shaydaddy
Shaydaddy Customs
Ok guys, so I've been tearing my hair out over this one for about a week, and my eyes are burning trying to sort through all the forum posts to get an answer.
I just finished a rebuild on my motor, got the motor back in frame, now when I put the bike into first it tries to lurch forward and dies. I have adjusted clutch over and over again to no avail. didn't have this issue before rebuild so i'm stumped. clutch basket is properly aligned. all clutch plates and springs are within tolerance and torqued to spec. one piece clutch rod with both ball bearings in place. new thrust bearing and washer. new clutch worm screw assembly. new clutch perch and adjuster.
any ideas please I've already registered it for cyclefest dayton in december and need to fix this problem so I can shake the bike down.
I just finished a rebuild on my motor, got the motor back in frame, now when I put the bike into first it tries to lurch forward and dies. I have adjusted clutch over and over again to no avail. didn't have this issue before rebuild so i'm stumped. clutch basket is properly aligned. all clutch plates and springs are within tolerance and torqued to spec. one piece clutch rod with both ball bearings in place. new thrust bearing and washer. new clutch worm screw assembly. new clutch perch and adjuster.
any ideas please I've already registered it for cyclefest dayton in december and need to fix this problem so I can shake the bike down.