isaiah935
XS650 New Member
Hey everyone, so during the process of my little chopper build I searched everywhere for some sort of rear brake reservoir that was small enough to look good on the back of my hard tail but i couldn't find anything that i really like. Long story short I designed a reservoir myself and actually had it 3D printed. Being as though your regular glycol based brake fluid is rough on a lot of plastics I opted to use a silicon based DOT5 brake fluid because it was a 3Dprinted part. It's been on the bike for three months now with no issues. I was just wondering what you guys though about it, if you think it's safe, not safe, or gonna kill me. Also would anyone be interested in this type of thing for your builds? I made it to fit a 78 xs650s but i don't know what other years and models that particular master cylinder was used. As always you guys are the best and happy building!
PS: I wouldn't mind if y'all just pretended all the welds looked good
PS: I wouldn't mind if y'all just pretended all the welds looked good