If I have the carbs off, I am holding them upside down so in the rested position the floats would have the valve shut. I am then measuring from gasket area surface of body to actual bottom of float. It would be difficult to do with the carbs on so I wanna get it right. Thanks for all reply
I know the measurement varies on plastic or brass. Just wanna be sure cause I did it to specs and I just feel like my left carb is almost full b4 shut off. Which is another question in the manual it states ,fuel level plus or minus 1mm does that mean the bowl can be full + or minus 1mm?
I know the measurement varies on plastic or brass. Just wanna be sure cause I did it to specs and I just feel like my left carb is almost full b4 shut off. Which is another question in the manual it states ,fuel level plus or minus 1mm does that mean the bowl can be full + or minus 1mm?