So I just installed the new valve guide. Now the new valve from yamaha wont slide into the new valve guide from mikes xs. it will only go like maybe 2 cm into the valve guide.
when installed it i used the guide tool and a hammer. wishing now that i used a press....
do you guys think a machine shop can recut the valve guide so it can accept the valve or should i just try another guide?
the old guide slides over the new valve so my thought is that somehow the guide is mis shaped.
I saw something on the forum about using a dremel to remove help with the mushrooming of the valve guide if that occurs, although my thought is if was to mushroom wouldnt that happen at the valve seal side and not the side with the valve face?
Has anyone else had this same issue with guides from mikes or do i just have super piss poor luck?